Enersol 4010 4'x10' Solar Pool Heater in a Box Kit
How It WorksPool water is pumped from the pool pump through the solar panels. Sun rays warm the water in the solar panels, heated water is then returned to the pool.
How Do I Size an Enersol System?First multiply the pool length by the width to get the surface area of the pool. Divide that number in half. This is your solar requirement number. Refer to the sizing chart for the number of boxes you will need. This is the minimum amount of square feet of solar required to heat your pool, 50% of the area of the pool. If you are heating an indoor pool, you will need to have 100% coverage.
Can I install on the Roof?
How big is your roof? The panels come in 10’ or 8’ lengths. They should be installed vertically. Leave 6” around the perimeter of the panels. (For example: if roof measurement from eave to peak is 9’, 8’ panels will fit) Measure the length to determine how many boxes will fit on the roof. One box of assembled panels is 51” (total header length) and 48” (width of rubber) Try to face panels south, southwest, or west.
Along with the panels, you will need a System Kit, which is sold separately. The system kit includes: an installation manual and DVD, installation tool, extra o-rings, o-ring lubricant, roof sealant, 2 end caps, 2 header end connectors, and warranty card. You will also need a valve to divert the water to the panels, either a 3 port manual valve, or an auto controller. Check Related Products below.
|Product Name||4'x10' Solar Pool Heater in a Box Kit|
|Manufacturer Part Number||4010|
|Substitute Part Numbers||AAA074-10, 04010|