Jandy Mechanical Shaft Seal, 13/16" ID
Jandy R0445500
This is the Polaris OEM Mechanical Shaft Seal is used on a Number of older pumps.
Jandy Stealth SHPF & SHPM Pumps: Used on serial number prior to P08FF0001
Polaris PB4-60 Booster Pumps: Used on serial number after PB120111001 or starting at AVEH050100
The Jandy® limited warranty does not apply to Jandy® branded products purchased through the Internet or other e-commerce platforms.
Product Overview
Specs & Details
| Product Name | Mechanical Shaft Seal, 13/16" ID |
| Manufacturer Part Number | R0445500 |
| Sku | TLD-101-2007 |
| UPC | 052337021845 |
- Polaris Pb4-60 Booster Pump Operation and Installation Manual|
Easy to install, good directions. Corrected my pump leak.
The seal kit for the new style PB4-60 pump works as it should. Removing the old seals takes a little patience to pop the ceramic seal (push from behind) and the graphite seal (twist and pull). The new ceramic seal will seat fully and does /not/ need or require silicon caulk as some YouTube vids say - don't do it! The graphite seal needs some twisting and encouragement to seat fully. Wear gloves when working with these seals - grease contamination will ruin them in short order. Touch the seal surfaces with a finger and... so much for those seals.
Tearing my polaris pool sweep apart to see why it wasn’t pumping revealed that the impeller had sheered off the shaff, so I needed a new one. I decided that the seal should be replaced while I was at it, so I found it online at poolzoom and ordered it. It arrived promptly and did the job.
California Proposition 65 Warning
WARNING: This product contains chemicals known to the state of California to cause cancer and birth defects or other reproductive harm. For more information: www.p65Warnings.ca.gov
