3HP Impeller for Aqua-Flo Flo-Master XP2E

IMPELLER 2HP XP-D11 SERIES OUTSIDE DIAMETER: 4-3/8" (A) THICKNESS: 1/4" (INSIDE THICKNESS AT OUTSIDE EDGE) THICKNESS: 1/2" (B) (OUTSIDE THICKNESS AT OUTSIDE EDGE) FRONT TO BACK: 3" (FROM END OF SHAFT TO FRONT ON INTAKE) INLET INSIDE DIAMETER: 1-7/8" INLET OUTSIDE DIAMETER: 2-1/8" SHAFT COVER LENGTH: 1-7/16" SHAFT COVER OD 5/8" (THIS IS WHERE THE IMPELLER SCREWS ONTO THE MOTOR SHAFT) MARKINGS: "91694200" IS MOLDED ONTO THE IMPELLER NEAR THE OUTSIDE EDGE OR THERE WILL BE 2 BLUE DOTS ON THE IMPELLER SHAFT.

Faceplate Cover Kit for Aqua-Flo Flo-Master XP2 pump.

1HP Impeller for Aqua-Flo Flo-Master XP & XP2 model pumps.

Aqua-Flo Flo-Master XP2 Suction Cover. 2-5/8" Inside Diameter on back side to receive impeller ring.

<p>6-1/2" Inside Diameter 3/32" Cross Section</p>

Aqua-Flo Flo-Master XP2 Volute. Fits 48 frame motors.

Aqua-Flo Flo-Master XP2 Volute. Fits 56 frame motors. 4" between center to center of bolts.

Aqua-Flo Flo-Master XP2 Volute. Fits 56 frame motors. 4-1/8" in between center to center of bolts.

<p>4HP Impeller for Aqua-Flo Flo-Master XP &amp; XP2 pumps.</p>

2" Tail Piece Fitting

Drain plug for Aqua-Flo pumps.

Aqua-Flo Flo-Master XP2 wear ring

11/16" Outside Diameter 1/2" Inside Diameter