waterway-executive-56-frame-pump-parts

Waterway Pump Shaft Slinger 313-1400. This slinger fits over the shaft of the motor and acts as a last line of defense to save a motor from a leaky mechanical seal.

Executive Volute O-Ring

Executive Wear Ring 1-3 HP

<p>waterway 805-0111 Drain Plug O-Ring</p>

<p>Executive 1 HP Impeller</p>

<p>Executive 4 HP Impeller</p>

<p>Executive Wear Ring 4-5 HP.</p>

5 HP Executive Impeller. Closed face impeller made for the Executive pump by Waterway Plastics. Rated at 5.0hp, it is used in a Waterway Executive pump wetend, and must be installed on a 5.0hp (or greater) thru bolt motor. Shaft seal sold separately Impeller Type : Closed Face Impeller Diameter OD : 4-1/2" Vane Width ID : 9/16" Eye Diameter OD : 2-3/8" Eye Length : 15/16" Impeller Width OD : 7/8" Seal Seat Depth : 3/4" Shaft Length : 1-1/4" Shaft Diameter OD : 5/8" Seal Seat Diameter OD : 1-3/8"

Complete side discharge wet end for 3HP Executive Pump. Fits 56Y frame motors. 2-1/2" plumbing size.

<p>Executive 2 HP Impeller</p>

<p>2.5"x2" Pump Union Assembly</p>

<p>2.5" Executive Wet End - 4HP, 56 Fr.</p>

<p>Magic Plastics 2in Pump Union</p>

<p>Volute Face Plate 2"</p>

<p>2" Executive Wet End - 5HP, 56 Fr.</p>

<p>Executive Volute w/ Inserts.</p><h3></h3><p>315-1220 has been renamed 315-1260 and part you will receive is marked 315-1260 w/ O-ring on the backside.</p>

Phillips Head Screw 8/32" x 7/16"

<p>2" Executive Wet End - 3HP, 56 Fr.</p>

<p>2.5" Executive Wet End - 2HP, 56Fr.</p>

2" Executive Wet End - 2HP, 56 Fr.